Tammy Delacruz. Door Hinges. November 21st , 2017.
The easy way to install the door and door hinges is to install the new door hinges where the old ones were. This only works if you selected the same size door hinges as you previously had on the door with proper hole-spacing. If not, you may have to use some wood putty to fill the old holes, and then put the new hinges wherever you would like. When deciding where the door hinges will go remember, doors are supposed to open into the room, they are also traditionally expected to open to a wall, not to flap in the open area of the room. If you have someone handy, you may want to bring them into play at this time. Line up the door where you think it should be placed, using shims to balance it off the ground enough that it will open and close.
Another way to tell if it is a good idea to replace your doors with pre-hung replacements is if the rest of the doors already cant in their frames. You can square them yourself, but if you are planning to replace these doors, go for the pre-hung. They take much less time to replace and come in pre-finished or raw wood. One last thing, is your door a left- or right-hanging door? Hmmm...you think for a minute. Nope, you are sure you havent heard that one. Dont worry its easy. When you are buying any type of hinged door; storm door, entry door, and even cabinet doors, OR when you are buying hinged door hardware; hinges especially and sometimes latches, the salesperson will eventually ask you whether it is a right- or left-hanging door. The way you figure it out is, when you pull open the door; does it open to your left or to your right? Whichever way it opens is the answer.
Most doors today are sold pre-hung, with hinges on them, when you get a new door it usually comes with factory standard door hinges. If you are remodeling you want to make sure the new door hinges fit the style of all the other ones in the house. Thankfully they are easy to swap out. The holes for door hinges are usually standard as long as you buy the same size that you had previously. The door hinges you have will likely have either two or three holes. How you change the door hinges depends on which style you have.
Whether its because your door is old and no longer works with your décor, or you want something a little more flashy in the space, trading out doors and door hinges is not too difficult of a job. Dont think you can do it? Think you need a lot of tools to get the job done? Think again. All you need is a few shims, or thin pieces of wood that can be slipped under the door to hold it at the right height, nails or an electric screwdriver and the door and door hinges. Here are the steps for taking on the installation process.
You should put the first screw in at this point, at the top of the door. Make sure someone is holding up the weight of the door (or keep it on shims) so the weight doesnt pull that screw out. Close the door and make sure it shuts properly. It should be hitting the strike plate evenly. If not, adjust the shim placement until you have even amounts of space all the way around and the door seems to be evenly set. Immediately put a screw in the bottom door hinges. This will make sure you have the door hinges lined up in a manner that will allow the door to open and close correctly.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does NewsPressRelease claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.