Tammy Delacruz. Door Hinges. November 26th , 2017.
The easy way to install the door and door hinges is to install the new door hinges where the old ones were. This only works if you selected the same size door hinges as you previously had on the door with proper hole-spacing. If not, you may have to use some wood putty to fill the old holes, and then put the new hinges wherever you would like. When deciding where the door hinges will go remember, doors are supposed to open into the room, they are also traditionally expected to open to a wall, not to flap in the open area of the room. If you have someone handy, you may want to bring them into play at this time. Line up the door where you think it should be placed, using shims to balance it off the ground enough that it will open and close.
If you are replacing three-hole door hinges, you should start by putting in the middle screw first, then put in the bottom screw. Finally you should put in the top screw. If you repeat this on both the top and bottom of a cabinet door you will be able to keep your door in alignment. If you have two-hole door hinges things can get a little trickier. The easiest way to do them is to have someone help you. Their job will be to hold the door in place while you put the screws in. You can also balance the door on something while you put the screws in. But, this can be a little frustrating if the door moves or shifts before you get both screws in place.
Geared continuous hinges are most often found in steel or aluminum. Lighter weight continuous piano hinges are often made of brass. The heavy duty commercial hinges distribute weight and stress along the full length of door and frame, thus preventing misaligned pivot points of individual hinges. Buyers should look for high quality hinges from well-known manufacturers. Cheaper products provide inferior performance and will require repair and replacement long before a higher grade hinge. Companies such as Stanley even provide a limited lifetime warranty on their commercial grade door hinges.
Another related lefty-righty question is: Does it really matter if you mix up right- and left-hanging cabinet door hinges? Not usually. Most door and cabinet door hinges can masquerade as each other if you rotate them 180°. The pins will drop in the same way and everything. In rare cases, the pin only goes in one way, the cabinet door hinges plate is shaped or decorated to only look right on its right (or left!) side. If in doubt, ask a contractor or cabinetmaker. Tip: If you are going to take your old doors or cabinet doors off, refinish them, and put them back on, I suggest labeling each of the cabinet door hinges as you take them off. In your kitchen for example, the top left-hanging hinge on the first cabinet on the east side of your kitchen could be marked: TLE1. That way everything will line up exactly as it did before you took them down.
No matter what you of cabinet door hinges you choose you still have to select a finish as well. From antique copper to polished chrome and everything in between the easiest route to take might be to match your cabinet knobs and drawer pulls. Not only will this make your cabinet door hinge shopping experience easier, but you will also complete you room with style and finesse. So even though they are small and you probably never thought about them being part of your décor, dont forget about your cabinet door hinges because your modern life hinges on hinges.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does NewsPressRelease claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.