Tammy Delacruz. Door Hinges. November 21st , 2017.
There are several types of door hinge available. The most common is the butt hinge. This consists of two flaps with screw holes attached by a pin or a rod. To take the door down all you would have to do is remove the pins. You can choose to add finials or balls to the pins for a decorative touch. Garage doors are usually attached with T-hinges. Shaped like the letter T the horizontal part is attached to the door frame while the vertical part is attached to the door. These hinges can be plain or ornamental and lift up rather than out. If you have folding doors you might use a Soss hinge. Named for its inventor this door hinge is recessed into the door edges so when the door is folded it is completely concealed. It must be installed exactly or it will not work.
Whether its because your door is old and no longer works with your décor, or you want something a little more flashy in the space, trading out doors and door hinges is not too difficult of a job. Dont think you can do it? Think you need a lot of tools to get the job done? Think again. All you need is a few shims, or thin pieces of wood that can be slipped under the door to hold it at the right height, nails or an electric screwdriver and the door and door hinges. Here are the steps for taking on the installation process.
The easy way to install the door and door hinges is to install the new door hinges where the old ones were. This only works if you selected the same size door hinges as you previously had on the door with proper hole-spacing. If not, you may have to use some wood putty to fill the old holes, and then put the new hinges wherever you would like. When deciding where the door hinges will go remember, doors are supposed to open into the room, they are also traditionally expected to open to a wall, not to flap in the open area of the room. If you have someone handy, you may want to bring them into play at this time. Line up the door where you think it should be placed, using shims to balance it off the ground enough that it will open and close.
Hinges come in a seemingly endless variety of styles, sizes and shapes. But if you know the basics you will able to find the right ones for your project in a flash. Dont worry about whether the hinge is labeled left or right handed. All this means is what side of the door you are hanging the hinges on, but all you need to do is flip them over and you can use them on the other side. You may also be unsure of what size of hinge you need. As long as it is proportional to the size of the door you neednt worry. Hinges are extremely strong. In fact they are generally eight to ten times stronger than the job they are called on to do.
Selecting the what you need is easy. Measure the old door that you are taking out of this space and write those measurements down. When it comes to selecting door hinges, consider what this door will be asked to do. If the door is going to get a lot of use you may want to use three 3-inch door hinges to make sure its sturdy and will hold in place. This is especially the case if it is an exterior door. One way to tell what kind of door hinges to choose is to look at what was being used on the door you are removing.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does NewsPressRelease claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.